Order no.: 0173860

PA-1250D

Order no.: 0173860

PA-1250D

Powerful and Energy-saving
The mono class D PA power amplifier PA-1250D is part of a new generation of equipment which combines a high power capability with an efficient energy utilisation, thus making an important contribution to climate protection. Furthermore, the user also saves electricity costs. Among other things, this is due to the digital 100V power amplifier providing a considerably higher efficiency of more than 90% compared to analogue units (approx. 70%). Furthermore, the thermal loss is considerably lower. Thus, the cooling requirements will be minimised and the service life of the PA-1250D will be further increased.
Mono class D PA power amplifier,
with an energy-saving effect.
  • 1 x 250 W
  • Class D concept with a high efficiency of more than 90% to cut energy costs
  • Additional integrated energy-saving functions, e.g. device automatically goes to standby mode when no input signal is present (as soon as an input signal is detected, the amplifier is automatically switched on again)
  • Requires a significantly lower rechargeable battery capacity for emergency power operation than 100 V analogue amplifiers
  • Clearly reduced cooling requirements due to low heat dispersion
  • Silent operation due to fanless cooling concept, thus especially suitable for noise-sensitive areas, e.g. offices, conference rooms or churches
  • Special protective circuits prevent damage caused by short circuit or overheating
  • Extensive, menu-controlled settings
  • Switchable 200 Hz high-pass filter, 6 dB/oct.
  • Additional priority input
  • RS-485 interface
  • LCD for the operating parameters
  • Mains operation or 24 V emergency power operation
Manufacturer information:
MONACOR INTERNATIONAL GmbH & Co. KG
Konsul-Smidt-Str. 68
28217 Bremen
Germany
info@monacor.com
Safety Notes and Warning Messages
The unit uses dangerous mains voltage. Leave servicing to skilled personnel only and do not insert anything into the air vents. Inexpert handling may result in electric shock.
During operation, there may be a hazard of contact with a dangerous voltage of up to 100 V at the speaker terminals. Always switch off the amplifier before making or changing any connections.
Do not operate the unit and disconnect the mains plug from the socket immediately if the unit or the mains cable is visibly damaged; if a defect might have occurred after the unit was dropped or suffered a similar accident, if malfunctions occur. In any case, the unit must be repaired by skilled personnel.
The unit is suitable for indoor use only. Protect it against dripping water and splash water, high air humidity and heat (admissible ambient temperature range: 0 - 40 °C).
Never pull the mains cable to disconnect the mains plug from the socket, always seize the plug.
The heat generated inside the unit must be dissipated by air circulation; never cover the air vents of the housing.
If the unit is to be put out of operation permanently, take it to a local recycling plant for a disposal which is not harmful to the environment.

About

Powerful and Energy-saving
The mono class D PA power amplifier PA-1250D is part of a new generation of equipment which combines a high power capability with an efficient energy utilisation, thus making an important contribution to climate protection. Furthermore, the user also saves electricity costs. Among other things, this is due to the digital 100V power amplifier providing a considerably higher efficiency of more than 90% compared to analogue units (approx. 70%). Furthermore, the thermal loss is considerably lower. Thus, the cooling requirements will be minimised and the service life of the PA-1250D will be further increased.
Mono class D PA power amplifier,
with an energy-saving effect.
  • 1 x 250 W
  • Class D concept with a high efficiency of more than 90% to cut energy costs
  • Additional integrated energy-saving functions, e.g. device automatically goes to standby mode when no input signal is present (as soon as an input signal is detected, the amplifier is automatically switched on again)
  • Requires a significantly lower rechargeable battery capacity for emergency power operation than 100 V analogue amplifiers
  • Clearly reduced cooling requirements due to low heat dispersion
  • Silent operation due to fanless cooling concept, thus especially suitable for noise-sensitive areas, e.g. offices, conference rooms or churches
  • Special protective circuits prevent damage caused by short circuit or overheating
  • Extensive, menu-controlled settings
  • Switchable 200 Hz high-pass filter, 6 dB/oct.
  • Additional priority input
  • RS-485 interface
  • LCD for the operating parameters
  • Mains operation or 24 V emergency power operation
Manufacturer information:
MONACOR INTERNATIONAL GmbH & Co. KG
Konsul-Smidt-Str. 68
28217 Bremen
Germany
info@monacor.com
Safety Notes and Warning Messages
The unit uses dangerous mains voltage. Leave servicing to skilled personnel only and do not insert anything into the air vents. Inexpert handling may result in electric shock.
During operation, there may be a hazard of contact with a dangerous voltage of up to 100 V at the speaker terminals. Always switch off the amplifier before making or changing any connections.
Do not operate the unit and disconnect the mains plug from the socket immediately if the unit or the mains cable is visibly damaged; if a defect might have occurred after the unit was dropped or suffered a similar accident, if malfunctions occur. In any case, the unit must be repaired by skilled personnel.
The unit is suitable for indoor use only. Protect it against dripping water and splash water, high air humidity and heat (admissible ambient temperature range: 0 - 40 °C).
Never pull the mains cable to disconnect the mains plug from the socket, always seize the plug.
The heat generated inside the unit must be dissipated by air circulation; never cover the air vents of the housing.
If the unit is to be put out of operation permanently, take it to a local recycling plant for a disposal which is not harmful to the environment.

Specifications

Peak output power 350 W
Power rating 250 W
Power rating at 100 V 250 W
Output impedance 100 V/40 Ω
Channels 1
Inputs 1.2 V, bal. (line)
Frequency range 50-18,000 Hz
Crossover network yes
S/N ratio > 100 dB(A)
THD < 0.5%
Power supply ˜ 230 V/50 Hz/350 VA,

8 W (standby mode),

DC 24 V/20 A,

280 mA (standby mode)

Mains voltage ~ 230 V
Mains frequency 50 Hz
Power consumption, operation 350 VA
Operating voltage (possible alternative) DC 24 V
Power supply (possible alternative) DC 20 A
Admiss. ambient temp. 0-40 °C
Width 482 mm
Height 88 mm
Depth 410 mm
Rack units, RU 2
Weight 7.5 kg
Connections screw contacts (inputs)

screw contacts (speakers)

Packaging dimensions (W x H x L) 0.48 x 0.185 x 0.545 m
Gross weight 9.53 kg
Net weight 7.91 kg
EAN code 4007754231762
Net weight 7.91 kg

Accessories for PA-1250D

Active/passive:
passive
Transmission technology:
cable
Total power rating:
80 W
Order no.: 0163450
Pair of slim line array design speakers in extruded aluminium cab...
Description:
inductive receiver
Suitable for:
loop amplifiers, sound reproduction systems
Power supply:
9 V battery
Order no.: 0176370
Induction loop receiver
Intended use:
audio
Connectors:
1 x 3-pole XLR inline jack,

1 x open cable ends

Length:
1 m
Order no.: 1000617
Adapter cable, XLR inline jack, 1 m
Channels:
10
Inputs:
2.5 mV, bal. (mic),

250 mV, bal. (line XLR),

250 mV, unbal. (line RCA)

Frequency range:
20-20,000 Hz (-0.5 dB)
Order no.: 0174770
10-channel PA preamplifier
Description:
splitter
Frequency range:
20-20,000 Hz
Input signal:
0.775 V
Order no.: 0171890
10-way PA line splitter
Order no.: 0172260
Hand-held microphone with integrated multifrequency transmitter, 863.1...
Description:
hand-held microphone transmitter
Transmission method:
wireless
Polar pattern:
cardioid
Order no.: 0172260
Hand-held microphone with integrated multifrequency transmitter,...
General information:
Description:
receiver unit
Carrier frequency range:
863.1-864.9 MHz
Order no.: 0172990
2-channel multifrequency receiver, 863.1-864.9 MHz

Services

SERVICE
Product & Purchasing Advice
SERVICE
Technical project management
SERVICE
Training at the MONACOR Academy
Contact
You can send us your question or request here.